Siemens SIMATIC IPC PX-39A - FCC (USA); Canada; Australia; New Zealand

Standards and approvals
10.6 FCC (USA)
SIMATIC IPC PX-39A
104 Operating Instructions, 08/2022, A5E51699601-AA
10.6 FCC (USA)
USA
Federal Communi-
cations Commis-
sion
Radio Frequency
Interference State-
ment
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communi-
cations. Operation of this equipment in a residential area is likely to cause harm-
ful interference in which case the user will be required to correct the interference
at his own expense.
Shielded Cables
Shielded cables must be used with this equipment to maintain compliance with
FCC regulations.
Modifications
Changes or modifications not expressly approved by the manufacturer could void
the user’s authority to operate the equipment.
Conditions of Op-
erations
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Responsible party for Supplier's Declaration of Conformity
Siemens Industry, Inc.
Digital Factory - Factory Automation
5300 Triangle Parkway, Suite 100
Norcross, GA 30092
USA
mailto: amps.automation@siemens.com (mailto: amps.automation@siemens.com)
10.7 Canada
CANADA
Canadian Notice
This Class A digital apparatus complies with Canadian ICES-003.
Avis Canadien
Cet appareil numérique de la classe A est conforme à la norme NMB-003
du Canada.
10.8 Australia / New Zealand
AUSTRALIA / NEW ZEALAND
This product meets the requirements of EN 61000-6-3 Generic standards – Emission standard
for industrial environments.
This product meets the requirements of the standard EN 61000-6-3 Generic standards -
Emission standard for industrial environments.