Siemens SIMATIC IPC277D

Installing and connecting the device
3.1 Preparing for installation
SIMATIC IPC277D
Operating Instructions, 12/2016, A5E03409486-AE
31
3.1.2
Identification data of the device
The device can be clearly identified with the help of this identification data in case of repairs
or theft.
Enter the identification data in the following table:
Order number 6AV...
Serial number
S VP
Product version ES
Windows "Product Key"
Ethernet address 1 (MAC)
Ethernet address 2 (MAC)
You can find this information on the rating plate and COA label. The rating plate is located on
the back of the unit. The COA label is only available with pre-installed Windows operating
systems and is affixed to the rear of the device.
Procedure
1. Take down the order number, serial number, product version (ES) and Ethernet
addresses from the rating plate.
The Ethernet addresses can also be found in the BIOS Setup (F2 key) under
"Main > Advanced > Peripheral Configuration".
Replacement device: On the rating plate, the order number of a replacement device
which is available from stock at short notice is listed under "Spare Part Space Units". The
replacement device is always supplied without storage media.
Note
Replacement device without storage media
When you order a replacement device, remove all the storage media, such as SSD,
CompactFlash card, from your device. Insert the storage media in the replacement
device.