Siemens SIMATIC IPC277D

SIMATIC IPC277D
Operating Instructions, 12/2016, A5E03409486-AE
53
Commissioning the device
4
4.1
General information on commissioning
CAUTION
Danger of burns
The surface of the device can reach temperatures of over 70 °C. Any unprotected contact
may cause burns.
Avoid direct contact during operation of the device. Touch the device only with appropriate
protective gloves.
Note
Windows Embedded Standard 7
Read the EWF and FBWF information
Two
configurable write filters (Enhanced Write Filter and File Based Write Filter) are
provided with Windows
Embedded Standard. Read the EWF/FBWF information if you
activate and use them, otherwise you may experience data loss.
Note
Configuring memory cards in the device
Memory cards used in a device need to be configured on that device. Memory cards
configured on other devices will not boot as the drive parameters will be different.
Requirement
● The device is connected to the power supply.
● The protective conductor is connected.
● The connection cables are plugged in correctly.
● The following hardware is available for initial commissioning:
– One USB keyboard
– One USB mouse
– A monitor/display