Installing and connecting the device
3.3 Connecting the device
SIMATIC IPC277D
Operating Instructions, 12/2016, A5E03409486-AE
41
Securing with clamps (can be ordered as options)
Requirement
● 2.5 mm hexagonal spanner
● IPC277D, 15" display: 6 clamps
● IPC277D, 19" display: 8 clamps
Clamps are available as an accessory.
1. Disconnect the device from the power supply.
2. Working from the front, insert the device into the mounting cutout.
3. Fasten the control unit from the rear using the clamps.
4. Tighten the setscrews to a torque of 0.4 - 0.5 Nm.
Accessories (Page 21)
To Next Page
Loading...
