Installing and connecting the device
3.3 Connecting the device
Operating Instructions, 01/2021, A5E43920357-AA
69
Procedure
1. Connect I/O devices to the corresponding sockets on the rear of the device. Information on
the position of the sockets is available in "Device ports (Page 24)".
2. Screw the desired strain relief ① with the fixing screw ② on the left and/or right of the
device.
3. Insert the detachable cable ties in the respective openings of the strain relief ③ and fasten
the cables with the cable ties.
4. Fasten the cables to the corresponding openings in the strain relief ④ using simple cable
ties.
Example: Cable fastened to strain relief with cable ties
To Next Page
Loading...
