Configuration
5
5.1 Configurations for SFC Visualization
Introduction
You can place objects in a WinCC display that enable you to open an SFC during runtime
operation.
The following objects can be used for this:
● Block icons
● "PCS 7 SFC Control"
● "PCS 7 SFC MultiChart Control"
● "PCS 7 SFC Topology Control"
● Any graphic object (such as a rectangle)
● A Windows object (such as a button)
Preparation
● Select the Options > 'Compile Multiple OSs' Wizard' > Start... command in SIMATIC
Manager in order to transfer the SFC charts and SFC instances to the OS.
● Then, carry out the Preparations for the Controls.
You can find additional information about this in the section: Preparing the controls
(Page 19)
Note
The controls "@PCS 7 SFC Panel Control" and "@PCS 7 SFC SP Control" supplied with SFC
Visualization are controls required internally in SFC Visualization. They have not yet been
approved for use in WinCC pictures.
You can configure the following objects for opening the SFC:
Configuring SFC block icons (Page 15)
Configuring SFC faceplates (Page 17)
Configuring status picture "PCS 7 SFC Control" (Page 20)
Configuring status picture "PCS 7 SFC MultiChart Control" (Page 22)
Configuring status picture "PCS 7 SFC Topology Control" (Page 24)
Configuring the SFC button (Page 25)
Configuring the SFC Browser Selection (Page 26)
SFC Visualization (V9.0)
Programming and Operating Manual, 05/2017, A5E41356392-AA 13
To Next Page
Loading...
