6.15 PCS 7 SFC MultiChart Control
PCS 7 SFC MultiChart Control
SFC MultiChart Control is used to operate and monitor several SFCs.
As it cannot be visualized in its configured length, the Control is provided with a scroll bar. The
#, SFC, and group display columns are always visible, regardless of the scroll bar position.
The following table describes the columns of the SFC multichart control.
Note
You can only start an SFC instance with control strategies or setpoints in the "Prepared Values"
view of the faceplate, because a control strategy and setpoints must be set prior to starting.
Columns Content Function
# Line Number Display for sorting
SFC Name of the SFC
(incl. name-forming element of the PH)
Double-clicking this name
opens the overview display
for the SFC.
Icon for the operating state;
you will find more detailed information
in the section: Icons for Operating
States (Page 95).
Display
Group
display
Group displays for messages,
in accordance with the configuration in
SFC
(e.g. alarm, warning, step error,
operator prompt, locked).
Displays 3 and 4 are set by default.
Display
Step error
Operator prompt The symbol is also displayed
when the displays
or
are shown.
Operating mode "AUTO" or "MANUAL" mode Allows changeover of the op‐
erating mode by means of a
selection in a drop-down list
box.
EA Enable
Auto
Check box for enabling changeover
to "AUTO" mode
Allows setting or resetting of
the enable.
Control strategy SFC instances: Name of current con‐
trol strategy
Step control mode Abbreviation for the step control mode
("T", "T or O", "T and O", "O", or "T / T
and O")
Allows changeover of the
step control mode by means
of a selection in a drop-down
list box.
Operating and monitoring SFCs
6.15 PCS 7 SFC MultiChart Control
SFC Visualization (V9.0)
Programming and Operating Manual, 05/2017, A5E41356392-AA 53
To Next Page
Loading...
