6.33 Operator control and monitoring using the Web client
6.33.1 Running SFC Visualization on the Web client
Introduction
Since V7.0, SFC Visualization on the Web client was restricted to operation of SFC block icons,
SFC faceplates and SFC controls.
Full Web capability is available as of V8.0. All the sections, overviews and zoom displays are
shown on the Web client and can be operated. All the API functions required in the Web
environment are supported.
Connection of the Web client to Web servers with different versions
The standard functions and project functions are published on the Web server. The Web client
downloads this data. The overall representation on the Web client therefore depends on the
version and project status of the Web server.
The controls installed on the Web client observe the Web server version and only call interface
functions that are actually supported by the given Web server version. The range of functions
of the Web server is therefore retained on the Web client.
Additional information
You can find information on the requirements for "SFC Visualization" on the Web client in the
section "What you need to know about the Web server and Web client (Page 30)".
Operating and monitoring SFCs
6.33 Operator control and monitoring using the Web client
SFC Visualization (V9.0)
Programming and Operating Manual, 05/2017, A5E41356392-AA 85
To Next Page
Loading...
