5.4 Adapting SFC faceplates
Introduction
You adapt the "Actual Values" (@pg_@sfc_type_actualsp.pdl) and "Prepared Values"
(@pg_@sfc_type_prepare.pdl) views in the Graphics Designer.
Procedure
1. Open the "@pg_@sfc_type_actualsp.pdl" or "@pg_@sfc_type_prepare.pdl " picture in the
Graphics Designer.
2. Double-click in the OCX area of the picture.
The "Properties of "@PCS 7 SFC SP Control"" dialog box opens.
3. In the "General" tab, use the '"Actual Values" view enabled' option to specify whether the
operator can edit the information in the setpoint column or if it is write-protected.
Note: This option can be set in the properties of the "Actual Values" and "Prepared Values"
views. It only affects the "Actual Values" view.
4. In the "Colors" tab, you can change the font and background colors of the respective OCX
elements.
Configuration
5.4 Adapting SFC faceplates
SFC Visualization (V9.0)
18 Programming and Operating Manual, 05/2017, A5E41356392-AA
To Next Page
Loading...
Need help?
General
