5.5 Preparing the controls
Introduction
You can prepare for the configuration of the controls in order to facilitate insertion of the controls
in a graphic picture.
Procedure
1. Open the desired picture in Graphics Designer.
2. Switch to the "Controls" tab in the object palette.
3. Select the "Add/Remove" command from the shortcut menu in the object palette.
The "Select OCX Controls" dialog box opens.
4. Select all entries in the list that begin with "PCS 7 SFC", for example, "PCS 7 SFC Control".
5. Click "OK" to close the dialog box.
The selected controls are now in the object palette and can be inserted directly from there into
the graphic picture using drag-and-drop.
Configuration
5.5 Preparing the controls
SFC Visualization (V9.0)
Programming and Operating Manual, 05/2017, A5E41356392-AA 19
To Next Page
Loading...
