5.6 Configuring status picture "PCS 7 SFC Control"
Introduction
The states of an SFC can be output to a graphic picture by means of an PCS 7 SFC Control
which is assigned to this SFC. This control is also referred to as the status picture (just like the
PCS 7 SFC MultiChart Control). To this, you place and configure the status picture in a graphic
picture in the WinCC Graphics Designer.
Placing the PCS 7 SFC Control in the graphic picture
Open the desired graphic picture in the Graphics Designer.
● If you have performed the preparation for the controls, use drag-and-drop to drag the "PCS 7
SFC Control" from the "Controls" object palette to the picture. You can find additional
information in the section: Preparing the controls (Page 19)
● If the controls are not yet in the object palette, proceed as follows:
– Select the following entry in the "Smart Objects" tool palette
– Draw a frame in the graphic picture for the object to be placed.
The selection list of all installed "Controls" will be displayed.
– Select "PCS 7 SFC Control".
Assigning parameters
1. Double-click the PCS 7 SFC Control.
The "Properties" dialog box opens.
2. Open the "General" tab.
3. Specify whether the SFC should be opened as a "Faceplate", "Overview" or "Section"
display.
The respective button in SFC Control will be labeled accordingly.
4. Click "Assign SFC."
Another dialog box opens listing all the SFCs on this OS.
5. Select the desired SFC.
6. Close the dialog box with "OK".
Under "Connected SFC:" you can see the current SFC name. When you close the
"Properties" dialog box with "OK," the current SFC name is also in the control.
Configuration
5.6 Configuring status picture "PCS 7 SFC Control"
SFC Visualization (V9.0)
20 Programming and Operating Manual, 05/2017, A5E41356392-AA
To Next Page
Loading...
