5.10 Configuring the SFC Browser Selection
Introduction
You place an object in the graphic display in order to call the SFC browser in runtime. Use this
browser to select the SFCs.
Procedure
1. In the Graphics Designer object palette, select the desired object and draw a frame in the
graphic display.
2. Double-click "Configure SFC Browser" in the Dynamic Wizard.
3. If an instructional page appears, ignore it by clicking "Next".
4. In the next dialog box, select the mouse action for opening the SFC.
5. Click "Finish" to complete the configuration.
Configuration
5.10 Configuring the SFC Browser Selection
SFC Visualization (V9.0)
26 Programming and Operating Manual, 05/2017, A5E41356392-AA
To Next Page
Loading...
