5.3 Configuring SFC faceplates
SFC faceplates
There are two types of faceplate templates for visualizing the various SFC instances of the
SFC types and for visualizing SFC charts in runtime:
● The "@pg_@sfc_rts.pdl" variant is used to visualize SFCs.
● The "@pg_@sfc_type.pdl" variant is used to visualize SFC instances of an SFC type. The
interface elements (setpoints, control strategies, for example) that are configured in the
"Characteristics" dialog box are included in this faceplate.
In addition to the display objects (type name/instance name, comment, group display, etc.)
that are created with the standard WinCC resources, the faceplates contain an OCX for
displaying and manipulating the operating state logic and an OCX (for SFC instance) for
displaying and manipulating the setpoints. You also use these OCX in SFC Visualization.
The meaning of the elements contained in the faceplate in all views is described in:
Operating and monitoring the SFC by means of faceplate (Page 32)
Configuration
The faceplates are supplied preconfigured and you can customize them individually.
You can also create your own faceplates from the templates. However, you use the available
OCX for displaying and manipulating the operating state logic and the setpoints (for SFC
instance).
You can find a detailed description of the configuration of faceplates in the manual
PCS 7
Programming Instructions for Blocks
.
Additional information
You can find additional information in the section: Adapting SFC faceplates (Page 18)
Configuration
5.3 Configuring SFC faceplates
SFC Visualization (V9.0)
Programming and Operating Manual, 05/2017, A5E41356392-AA 17
To Next Page
Loading...
