6.7 "SFC Instance" faceplate, "Prepared Values" view
"Prepared Values" view
The view is identical to the following view: "SFC Instance" faceplate, "Actual Values" view
(Page 37). You can change the control strategy and the setpoints here.
The changes made in this view are applied the next time you start the sequencer in MANUAL
mode.
Note
You can only ever start an SFC instance in the faceplate in the "Prepared Values" view.
This is most important if control strategies or setpoints are being used, because a control
strategy and setpoints have to be set prior to starting.
Operating and monitoring SFCs
6.7 "SFC Instance" faceplate, "Prepared Values" view
SFC Visualization (V9.0)
42 Programming and Operating Manual, 05/2017, A5E41356392-AA
To Next Page
Loading...
