Click "Faceplate" to open the SFC faceplate.
The button for the selection of the SFC display is defined during the configuration of the
PCS 7 SFC control.
You can choose from the following display options:
● Faceplate
● Overview
● Section
If "S" is displayed, the system also opens the "Properties" dialog box for the step.
Click on "S" to open the detail display for the SFC and center the active step using the error
acknowledgement button.
If "O" is displayed, the system also opens the "Properties" dialog box for the transition.
Click on "O" to open the detail display for the SFC and center the active transition using the
acknowledgement button of the operator prompt.
Operating and monitoring SFCs
6.14 PCS 7 SFC Control
SFC Visualization (V9.0)
52 Programming and Operating Manual, 05/2017, A5E41356392-AA
To Next Page
Loading...
