Operator inputs in the "Properties" dialog box of the transition
The following operator inputs are possible in the dialog box:
● Closing the dialog box using the "Close" button
● Confirming the operator request using the "O" button
● Selecting the previous or next active transition using the " T <- " / " -> T " button
● Option: "Update"
set / reset. This switches automatic tracing on or off.
● Option: "f(x)" button for the corresponding address as described above.
● Option: "Condition (technological)" button as described above.
Operating and monitoring SFCs
6.29 "Properties" Dialog Box for the Transition
SFC Visualization (V9.0)
Programming and Operating Manual, 05/2017, A5E41356392-AA 75
To Next Page
Loading...
