Siemens SIMATIC S7 User Guide

SIMATIC Automation Tool V2.1 user guide
Manual, V2.1.1 07/2016, A5E33042676-AC
121
SIMATIC Automation Tool device support
7
7.1
Unrecognized firmware versions and devices
The device support tables show the correspondence between SIMATIC Automation Tool
V2.1, SIMATIC device model, possible firmware versions, and supported tool operations.
If you connect an unrecognized SIMATIC device on your network, then there are two
possibilities.
● The SIMATIC Automation Tool V2.1 recognizes the device article number, but the
firmware version is newer than latest supported firmware version. In this case, the device
is loaded in the Device table, but the supported tool operations are restricted to those that
were possible with the latest supported firmware version.
● The SIMATIC Automation Tool V2.1 does not recognize the article number. In this case,
the device is not supported, no entry is made in the Device table, and no tool operations
are possible.
7.2
S7-1200 CPU support
S7-1200 operation support and firmware version
A check mark (✓) means that the operation is supported. Standard CPUs have only the
firmware version number in the column header. Fail-Safe CPUs have "Fail-Safe" in the
column header.
S7-1200
V1.x
V2.x
V3.x
V4.0
V4.1
Fail-Safe
V4.1
Scan for devices
✓
✓
✓
✓
✓
✓
Flash LED
✓
✓
✓
✓
✓
✓
Set IP address
✓
✓
✓
✓
✓
✓
Set PROFINET name
✓
✓
✓
✓
✓
✓
Set time to PG/PC time
✓
✓
✓
✓
✓
✓
Program update
✓
✓
✓
✓
✓
Firmware update
✓
✓
✓
Put CPU in RUN/STOP
✓
✓
✓
✓
✓
✓
Reset CPU memory
✓
✓
✓
✓
✓
✓
Read Diagnostic buffer
✓
✓
✓
✓
✓
✓
Upload service data
✓
✓
✓
✓
✓
✓
Backup and Restore
Reset to factory defaults
✓
✓
✓
✓
✓

Siemens SIMATIC S7 Specifications

General

Brand	Siemens
Model	SIMATIC S7
Category	Controller
Language	English