Siemens SIMATIC S7 - Set Time in Cpus

Tool operations
3.13 Set time in CPUs
SIMATIC Automation Tool V2.1 user guide
Manual, V2.1.1 07/2016, A5E33042676-AC
51
3.13
Set time in CPUs
Set time in CPUs to current PG/PC time
The Time button will set the time for selected CPUs to your current PG/PC time. Time
transformation information for time zone and daylight saving time is not changed and must
be modified in the TIA Portal Project.
1.
Click the left
-side check box on devices to include in the operation. You can use the
top check box, right
-click shortcut menu, or the Edit menu for "Select All" and "Un-
select All" commands.
2.
Select "Set Time" from the Network menu o
r click the "Set time in devices to PC
time" toolbar button.
3.
Click the "Continue" button on the "Set Time" dialog box.
4.
The system time on selected CPUs is set to your current PG/PC time.
5.
The Event log below the device table shows the results of this operation.
The selected devices in the following image set their time to your current PG/PC time when
the Set Time command is executed.