Siemens SIMATIC S7 - Set Cpus to RUN or STOP Mode

Tool operations
3.5 Set CPUs to RUN or STOP mode
SIMATIC Automation Tool V2.1 user guide
34 Manual, V2.1.1 07/2016, A5E33042676-AC
3.5
Set CPUs to RUN or STOP mode
Change CPUs to RUN mode
1.
Click the left
-side check box on devices to include in the operation. You can use
the top check box, right
-click shortcut menu, or the Edit menu for "Select All" and
"Unselect All" commands.
2.
Select RUN from the Network menu o
r click the RUN toolbar button. A valid pro-
gram must exist in the CPU before it can enter RUN mode.
3.
Selected CPUs are set to RUN mode.
4.
The Mode and Operating state columns in the device table indicate the current
CPU state. Yellow means STOP mode
. Green means RUN mode, and RED
means CPU fault.
5.
The Event log below the device table shows the results of this operation.