Siemens SIMATIC S7 - Download New IP, Subnet, and Gateway Addresses

Tool operations
3.3 Download new IP, subnet, and gateway addresses
SIMATIC Automation Tool V2.1 user guide
32 Manual, V2.1.1 07/2016, A5E33042676-AC
3.3
Download new IP, subnet, and gateway addresses
Change IP addresses
Use the following steps to update the IP addresses.
1.
Click the "IP Address" tab.
2.
Click the left
-side check box on devices to include in the operation. You can use the
top check box, right
-click shortcut menu, or the Edit menu for "Select All" and "Uns
e-
lect All" commands.
3.
Enter address changes in the "New IP", "New subnet", and "New Gateway" co
l-
umns.
4.
Select Download from the Network menu or click the Download button on the
toolbar
5.
The Download operation sets the IP, subnet, and gateway addresses in the selected
devices.
6.
The Event log below the device table shows the results of this operation.