Siemens SIMATIC S7 User Guide

SIMATIC Automation Tool device support
7.4 ET 200SP CPU support (Distributed I/O controller based on ET 200SP and S7-1500)
SIMATIC Automation Tool V2.1 user guide
Manual, V2.1.1 07/2016, A5E33042676-AC
123
7.4
ET 200SP CPU support (Distributed I/O controller based on ET
200SP and S7-1500)
ET 200SP CPU operation support and firmware version
A check mark (✓) means that the operation is supported. Standard CPUs have only the
firmware version number in the column header. Fail-Safe CPUs have "Fail-Safe" in the
column header.
ET 200SP CPU
V1.6
V1.7
V1.8
Fail-Safe
V1.7
V1.8
Scan for devices
✓
✓
✓
✓
✓
Flash LED
✓
✓
✓
✓
✓
Set IP address
✓
✓
✓
✓
✓
Set PROFINET name
✓
✓
✓
✓
✓
Set time to PG/PC time
✓
✓
✓
✓
✓
Program update
✓
✓
✓
Firmware update
✓
✓
✓
✓
✓
Put CPU in RUN/STOP
✓
✓
✓
✓
✓
Reset CPU memory
✓
✓
✓
✓
✓
Read Diagnostic buffer
✓
✓
✓
✓
✓
Upload service data ✓ ✓ ✓ ✓ ✓
Backup
✓
✓
✓
✓
✓
Restore
✓
✓
✓
Reset to factory defaults
✓
✓
✓

Siemens SIMATIC S7 Specifications

General

Brand	Siemens
Model	SIMATIC S7
Category	Controller
Language	English