Siemens SIMATIC S7 - ET 200 S Support (PROFINET I;O)

SIMATIC Automation Tool device support
7.8 ET 200S support (PROFINET I/O)
SIMATIC Automation Tool V2.1 user guide
126 Manual, V2.1.1 07/2016, A5E33042676-AC
7.8
ET 200S support (PROFINET I/O)
ET 200S operation support and firmware version
A check mark (✓) means that the operation is supported.
ET 200S
V3.x
V5.x
V6.x
V7.x
Scan for devices
✓
✓
✓
✓
Flash LED
✓
✓
✓
✓
Set IP address
✓
✓
✓
✓
Set PROFINET name
✓
✓
✓
✓
Set time to PG/PC time
Program update
Firmware update
✓
✓
✓
✓
Put CPU in RUN/STOP
Reset CPU memory
Read Diagnostic buffer
Upload service data
Backup and Restore
Reset to factory defaults
✓
✓
✓
✓
Note
ET 200S CPU not supported
The ET 200S CPU is not supported by the SIMATIC Automation Tool