Menu, toolbar, and shortcut key reference
5.2 Toolbar icons
SIMATIC Automation Tool V2.1 user guide
Manual, V2.1.1 07/2016, A5E33042676-AC
65
New: Create a new SIMATIC Automation Tool project file with the ".sat" file name extension.
Open: Display an "Open" dialog that can browse to a folder, select a project file, and provide a password to
open the encrypted project file.
Save the opened project data to a file. If no filename and password are assigned, then the "Save As" dialog is
displayed.
Cut the selected data and copy the data to the clipboard. Clipboard data are compatible with Excel so data can
be shared between the two applications.
Copy the selected data to the clipboard.
Paste the data contained in the clipboard to the selected field(s).
Scan the selected network interface for accessible CPUs and modules.
Download data entered in the SIMATIC Automation Tool to devices on the network. Depending on the current
tab selection, either IP addresses, PROFINET names, program updates, firmware updates, or restore data from
a backup file are downloaded.
RUN: Put selected CPUs in RUN mode.
STOP: Put selected CPUs in STOP mode.
Flash the LEDs on selected devices. Use this feature to identify the physical location of a device.
Reset factory default values in selected CPUs.
Memory reset: Reset the memory on selected devices.
Upload service data: Upload service information from a CPU.
Set time: Set the system time in selected CPUs to current PG/PC time.
Backup Device: Create .Backup data Perform a data backup operation.
Diagnostics: Read a CPU diagnostic buffer
Network interface drop-down list: Select the Ethernet network interface that is con-
nected to the industrial control network.
To Next Page
Loading...
