Siemens SIMATIC S7 - Page 35

Tool operations
3.5 Set CPUs to RUN or STOP mode
SIMATIC Automation Tool V2.1 user guide
Manual, V2.1.1 07/2016, A5E33042676-AC
35
Change CPUs to STOP mode
1.
Click the left
-side check box on devices to include in the operation. You can
use the top check box, right
-click shortcut menu, or the Edit menu for "Select
All" and "Unselect All" commands.
2.
Select STOP from the Network menu or click the STOP button on the toolbar.
3.
Selected CPUs are set to STOP mode.
4.
The Mode and Operating state co
lumns in the device table indicate the current
CPU state. Yellow means STOP mode. Green means RUN mode, and RED
means CPU fault.
5.
The Event log below the device table shows the results of this operation.