Summary
5–3
IP244
C79000–B8576–C861–02
1 Summary
These programming instructions describe the function block
FB 162 (PER:TREG) ”parameter assignment and control of temperature controller”
Each of the following programmable controllers has its own function block with the name FB 162
PER:TREG:
– S5-115U (CPU 941 to CPU 944 and CPU 941B to CPU 944B)
– S5-115U (CPU 945)
– S5-135U (CPU 922 from version A09, CPU 928 and CPU 928B)
– S5-155U (CPU 946/947 and CPU 948)
The appropriate function block is used in conjunction with the
temperature controller module 6ES5 244-3AA22 and -3AB31.
These programming instructions assume that you are familiar with the operating instructions for the
temperature controller module and the programmable controller.
An example in Part 5 of the manual illustrates the application of the function block.
The function blocks and example are on the S5-DOS diskette in the following files:
S5-115U (CPU 941 to CPU 944 and CPU 941B to CPU 944B) : S5NA50ST.S5D
S5-115U (CPU 945) : S5NA55ST.S5D
S5-135U (CPU 922 from version A09, CPU 928 and CPU 928B) : S5NB22ST.S5D
S5-155U (CPU 946/947 and CPU 948) : S5NA60ST.S5D
When using the CPU 922, CPU 928 or CPU 928B in the S5-155U, the file S5NB22ST.S5D should
be used.
To Next Page
Loading...
