IP244
C79000–B8576–C866–01
7–14
3.1 Overview
This document is a supplement to Chapter 4 of the Device Manual. It descri-
bes the standard block of the IP 244 temperature control module for SIMA-
TIC S7-400.
The IP 244 temperature control module can be used through the adapter casing
in the SIMATIC S7-400 automation system or through the IM 463-2 and IM 314
interface modules in the S5 extension unit.
There is a new standard block for this purpose that is executable in the CPUs of
the S7-400 automation system.
The standard function is delivered on a diskette in the form of a SETUP.
The SETUP is only executable under Windows 95; it requires an installed
STEP 7.
When SETUP is executed, a library, that only contains the standard function for
the IP 244, and a programming example are created.
An on line hep is provided for the standard function.
Introduction
Software delivery
form
FC162
To Next Page
Loading...
