Test Program
IP244
C79000–B8576–C862–02
6–4
2 Hardware Requirements
The following hardware is required for the example:
– a PG 685 programmer
– one of the following programmable controllers:
– S5-115U (CPU 941 to CPU 944 or CPU 941B to CPU 944B)
– S5-115U (CPU 945)
– S5-135U (CPU 922 from version A09)
– S5-135U (CPU 928 -3UA12/-3UB11)
– S5-155U (CPU 946/947 or CPU 948)
– one simulator suitable for the digital input module
– one digital input module 6ES5 420-... coded for IB4
1)
DDDDD
D
D
– one digital output module 6ES5 441-... coded for QB4
1)
D
DDDDD
D
– one IP 244 temperature controller module coded with the module address 160
DDDD
D
DD DDDDDD
D
The module is addressed in the P area (A77: switches 5, 7 and 8). The remaining jumpers and
switches on the module must be set for the selected mode.
1)
With the S5-115U the following modules are required instead of those listed above:
– one digital input module 6ES5 420-... (fixed slot coding), inserted in slot 1 of the central controller (IB4 to IB7)
– one digital output module 6ES5 441-... (fixed slot coding), inserted in slot 2 of the central controller
(QB8 to QB11).
To Next Page
Loading...
