Technical information
7.1 Certificates and approvals
IFP V2, IFP V2 PRO, IFP V2 ETH
86 Operating Instructions, 03/2023, A5E46641410-AE
Underwriters Laboratories Inc., to
• UL 61010-2-201
E-file numbers:
– Standard versions and extended versions : E222109
– Ethernet monitors and PRO devices: E472610
• CAN/CSA C22.2 No. 61010-2-201
• UL 121201 (Hazardous Location)
• CAN/CSA C22.2 No. 213 (Hazardous Location)
Standard versions, extended versions devices approved for use in
• Class I, II, III, Division 2, Group A, B, C, D, F, G; T4
• Class I, Zone 2, Group IIC T4
• Class II, Zone 22, Group IIIA, IIIB, IIIC T135
Ethernet monitors and PRO devices approved for use in
• Class I, Division 2, Group A, B, C, D; T4
• Class I, Zone 2, Group IIC T4
FM Approval
Factory Mutual Research (FM) conforming to
• Approval Standard Class number 3611, 3600, 3810, ANSI/ISA 61010-1, ANSI/UL 121201
• CAN/CSA C22.2 No. 213
• CAN/CSA C22.2 No. 61010-1
Approved for use in
• Class I, II, III, Division 2, Group A, B, C, D, E, F, G; T4
• Class I, Zone 2, Group IIC T4
• Class II, Zone 22, Group IIIA, IIIB, IIIC T135
Installation Instructions for cFMus:
WARNING – Do not remove or replace while circuit is live when a flammable or combustible
atmosphere is present.
WARNING – Substitution of components may impair suitability of the equipment.
CAUTION – To prevent injury, read the manual before use.
Additional Instructions for cFMus, built-in devices:
WARNING – The equipment is intended to be installed within an enclosure/control cabinet.
The inner service temperature of the enclosure/control cabinet corresponds to the ambient
temperature of the module. Use cables with a maximum permitted operating temperature of
at least 20 °C higher than the maximum ambient temperature.
To Next Page
Loading...
Need help?
General