Siemens SIMATIC V2 - Page 87

Technical information
7.1 Certificates and approvals
IFP V2, IFP V2 PRO, IFP V2 ETH
Operating Instructions, 03/2023, A5E46641410-AE
87
ATEX/UKEX/IECEx approval
Notes on use in hazardous areas
Observe the following FAQ regarding the use of an HMI device in hazardous areas: ATEX-FAQ
(https://support.industry.siemens.com/cs/ww/en/view/291285)
When using the device in hazardous areas, ensure that all plugs connected to the device are
secured in a captive manner, see section "Securing cables for use in hazardous areas
(Page 71)".
You can find certificates on explosion protection, EC/EU declarations of conformity, product
approvals and other certifications on the Internet at the following addresses:
• IFP certificates (https://support.industry.siemens.com/cs/ww/en/ps/16788/cert)
• IFP PRO certificates (https://support.industry.siemens.com/cs/ww/en/ps/21662/cert)
ATEX approval
For an HMI device with "Ex" marking, the following approvals apply according to the
following standards.
• Standards:
– EN 60079-0:2018
– EN 60079-7:2015 +A1:2018
– EN 60079-31:2014
• Approvals:
II 3 G
II 3 D
Ex ec IIC T4 Gc and
Ex tc IIIC T 70 °C Dc or
II 3 G
Ex ec IIC T4 Gc (6AV7860-3EH00-0AA0)
• ATEX certificate number:
DEKRA 19ATEX0125X
UKEX approval
For an HMI device with "Ex" marking, the following approvals apply according to the
following standards.
• Standards:
– EN 60079-0:2018
– EN 60079-7:2015 +A1:2018
– EN 60079-31:2014
• Approvals:
II 3 G
II 3 D
Ex ec IIC T4 Gc and
Ex tc IIIC T 70 °C Dc or
II 3 G
Ex ec IIC T4 Gc (6AV7860-3EH00-0AA0)