Decommissioning and disposal
10
WARNING
Risk of death and crushing as a result of permanent magnet elds
Severe injury and material damage can result if you do not take into consideration the safety
instructions relating to the permanent magnet elds of the secondary sections.
• Observe the information in Chapter "Danger from strong magnetic elds (Page29)".
10.1 Decommissioning
Sequence when decommissioning and disassembling the motor
WARNING
Risk of injury and material damage
Injury can occur if you do not observe the specied sequence when decommissioning and
disassembling the motor. Further, motor components could be damaged or destroyed.
• Comply with the specied sequence when carrying out decommissioning work.
• Dismantle the motors by carrying out the work steps of the respective procedure for
installing the motor in the reverse order.
Procedure
1. Bring the motor into a no-voltage condition. Wait until the DC link of the power unit has been
discharged.
2. Allow the motor to cool down for at least 30min.
3. Disconnect the power and signal cables.
4. Insulate uncovered power connections.
5. Remove chips, dirt, foreign particles, etc. from the motor.
Naturally-Cooled 1FN3 Linear Motors
Operating Instructions, 06/2023, A5E52220465B AB 115
To Next Page
Loading...
Need help?
General