Commissioning
7
The following information refers to commissioning the hardware components. Siemens
provides commissioning support through its Technical Support organization.
The motor can only be commissioned when it has been installed and integrated in a
functioning system. The commissioning documentation of all the system components must
be taken into account for the commissioning.
7.1 Safety instructions for commissioning
WARNING
Risk of death and crushing as a result of permanent magnet elds
Severe injury and material damage can result if you do not take into consideration the safety
instructions relating to the permanent magnet elds of the secondary sections.
• Observe the information in Chapter "Danger from strong magnetic elds (Page29)".
WARNING
injury and material damage if EMC safety requirements are not observed
Risk of death, serious personal injury, and/or material damage can occur if a machine that does
not fulll the recognized EMC safety requirements is commissioned.
• Plants and machines with converter-fed low-voltage three-phase motors must fulll the
protection requirements of EMC Guideline 2014/30/EU.
• The plant engineer is responsible for ensuring that installation is carried out in an EMC-
compliant manner. Apply the EMC installation guideline of the converter manufacturer. For
Siemens converters, this is available under document order No. 6FC5297-□AD30-0□P□.
Naturally-Cooled 1FN3 Linear Motors
Operating Instructions, 06/2023, A5E52220465B AB 97
To Next Page
Loading...
Need help?
General