Siemens SIMOTICS L-1FN3 - Training; Important Product Information; Intended Use

1.4.6 Training
Description
SITRAIN – Digital Industry Academy o󹪜ers a comprehensive range of training courses on
Siemens industrial products – directly from the manufacturer, for all industries and use cases, for
all knowledge levels from beginner to expert.
More information can be found on the Internet via the following address (
https://
www.siemens.com/sitrain).
1.5 Important product information
1.5.1 Intended use
WARNING
Risk of death and material damage as a result of incorrect use
There is a risk of death, serious injury and/or material damage when direct drives or their
components are used for a purpose for which they were not intended.
• Only use the motors for industrial or commercial plants and systems.
• Do not install the motors in hazardous zones if the motors have not been expressly and
explicitly designed and authorized for this purpose. Carefully observe any special additional
notes provided.
• Only use direct drives and their components for applications that Siemens has explicitly
speci󹪝ed.
• Protect the motors against dirt and contact with corrosive substances.
• Ensure that the installation conditions comply with the rating plate speci󹪝cations and the
condition speci󹪝cations contained in this documentation. Where relevant, take into
account deviations regarding approvals or country-speci󹪝c regulations.
• Contact your local sales partner if you have any questions relating to proper and intended
use.
• If you wish to use special versions and design versions whose technical details vary from the
motors described in this document, then you must contact your local sales partner.
Introduction
1.5Important product information
Naturally-Cooled 1FN3 Linear Motors
14 Operating Instructions, 06/2023, A5E52220465B AB