4.2.3 Storage
Storing indoors
• Apply a preservation agent (e.g.Tectyl) to bare external motor components if this has not
already been carried out in the factory.
• Store the motors as described in Section "Ambient conditions for long-term storage and
transport". The storage room/area must meet the following conditions:
– Dry
– Dust-free
– Free of vibration
– Well ventilated
– Protected against extreme weather conditions
– The air inside the room or space must be free of any aggressive gases
• Protect the motor against shocks and humidity.
• Make sure that the motor is covered properly.
Protection against humidity
If a dry storage area is not available, then take the following precautions:
• Wrap the motor in humidity-absorbent material. Then wrap it in foil so that it is air tight.
• Include several bags of desiccant in the sealed packaging. Check the desiccant and replace
it as required.
• Place a humidity meter in the sealed packaging to indicate the level of air humidity inside it.
• Inspect the motor on a regular basis.
Preparations for use
4.2Transporting and storage
Naturally-Cooled 1FN3 Linear Motors
56 Operating Instructions, 06/2023, A5E52220465B AB
To Next Page
Loading...
Need help?
General