Parameter assignment / addressing
6
6.1 Software requirements
Engineering
The
following requirements must be satisfied for the commissioning of the SIMOTION D410‑2
Control Units:
● SIMOTION D410‑2 DP: at least SCOUT V4.3 SP1 HF1 and firmware V4.3 SP1 HF2
● SIMOTION D410‑2 DP/PN: at least SCOUT V4.3 SP1 HF3 and firmware V4.3 SP1 HF3
Please note the information on the latest SIMOTION SCOUT DVD.
For information on how to install SIMOTION SCOUT on your PG/PC, see the
SIMOTION SCOUT
Configuration Manual.
Note
The software configuration is described in this manual based on SIMOTION SCOUT and
SIMATIC STEP 7 Version V5.x.
Information of configuration of the SIMOTION D Control Units in the Engineering Framework
Totally
Integrated Automation Portal (SCOUT in the TIA Portal), you will find in the configuration
manual
SIMOTION SCOUT TIA
.
The TIA Portal requires at least SIMOTION SCOUT V4.4 and SIMOTION D4xx‑2 Control Units
as of firmware V4.3.
SIMOTION D410-2
Commissioning and Hardware Installation Manual, 01/2015 103
To Next Page
Loading...
Need help?
General
