8.5 SIMOTION CompactFlash card
8.5.1
Changing the CompactFlash card
Requirement
NOTICE
Damage to the CompactFlash card from electrical fields or electrostatic discharge
The CompactFlash card is an ESD-sensitive component.
De-energize the SIMOTION D410‑2 device before inserting or removing the CompactFlash
card. The SIMOTION D410‑2 is in a de-energized state when all the LEDs are OFF.
Comply with the ESD rules.
Procedure
To change the CF card, proceed as follows:
1.
Switch off the power supply.
2. Remove the CF card from the plug-in slot on the SIMOTION D410-2.
To do this, grasp the gripping cavity between your thumb and forefinger and pull the card
out.
3. Gently insert the new CF card into the empty plug-in slot until it clicks into place. The
direction of insertion of the CF card is indicated by an arrow located on both the plug-in slot
and the CF card.
The properly inserted card does not protrude from the SIMOTION D410-2 housing.
4. Switch the power supply on again.
Service and maintenance
8.5 SIMOTION CompactFlash card
SIMOTION D410-2
Commissioning and Hardware Installation Manual, 01/2015 291
To Next Page
Loading...
