8.3.11 Save project, compile and check consistency
Procedure
1.
Save and compile the project from the "Project" > "Save and recompile all" menu.
2. Then perform a consistency check with the "Project" > "Check consistency" menu.
If error messages occur, correct these and repeat the operation.
Note
Note the difference between
●
"Save and recompile all" and
● "Save and compile changes"
Save and recompile all
All sources of the entire project are recompiled with this command.
The
command is suitable if you are quite sure that all the old data from older SCOUT versions
should be removed and replaced with new compilation results.
Use this command if you specifically want to convert a project from an earlier SCOUT version
to a newer version. In this way, you take over all error corrections and optimizations.
Save and compile changes
On this command, the whole project is searched for changes. Therefore only the changes are
compiled. Use this command for day-to-day operations within a SCOUT version.
Service and maintenance
8.3 Customizing the project
SIMOTION D410-2
280 Commissioning and Hardware Installation Manual, 01/2015
To Next Page
Loading...
Need help?
General
