Siemens SINAMICS GM150 - Page 11

Table 8-9 LEDs of the Power Stack Adapters ..........................................................................................162
Table 8-10 LEDs of the DM10 diagnostics module .....................................................................................163
Table 9-1 Technical specifications of the backup battery..........................................................................185
Table 9-2 Tightening torque for screws.....................................................................................................187
Table 9-3 Tightening torques for screw terminals for copper cables without cable lug 1).........................188
Table B-1 Standards and conformity .........................................................................................................207
Figures
Figure 2-1 ESD information ..........................................................................................................................22
Figure 3-1 Design of the power unit..............................................................................................................32
Figure 3-2 Basic Line Module with diodes in 12-pulse configuration............................................................33
Figure 3-3 Motor Module ..............................................................................................................................33
Figure 3-4 Overview of PSA interfaces.........................................................................................................35
Figure 3-5 AVT combination module ............................................................................................................39
Figure 3-6 Design when using IGBTs...........................................................................................................39
Figure 3-7 Overview ....................................................................................................................................40
Figure 3-8 Schematic diagram: Printed circuit board of the diagnostics module..........................................41
Figure 3-9 Logical design of the DM10 diagnosis module............................................................................42
Figure 4-1 Example of attaching and displaying the shock and tilt indicators ..............................................59
Figure 4-2 Example illustration of centers of gravity.....................................................................................61
Figure 4-3 Lifting bar label............................................................................................................................63
Figure 4-4 Securing the lifting rods...............................................................................................................63
Figure 4-5 Transporting a transportation unit (still in packaging) with a crane .............................................65
Figure 4-6 Example: Label with instructions for opening the doors..............................................................67
Figure 5-1 Removing the support rails..........................................................................................................72
Figure 5-2 Screwing cabinets together.........................................................................................................73
Figure 5-3 Grounding bar .............................................................................................................................75
Figure 5-4 Connecting the DC bus ...............................................................................................................76
Figure 5-5 Remove the screws.....................................................................................................................77
Figure 5-6 Install battery...............................................................................................................................78
Figure 6-1 Shield connection using a clip.....................................................................................................83
Figure 6-2 Bridging shield gaps....................................................................................................................83
Figure 6-3 Potential concept.........................................................................................................................84
Figure 6-4 Grounding lug..............................................................................................................................86
Figure 6-5 Example: Connecting the power cables......................................................................................87
Figure 6-6 Connection of the supply-system power cable............................................................................89
Figure 6-7 Connecting the external encoder to the SMC30 Sensor Module ................................................92
Figure 6-8 Connection example 1: HTL encoder, bipolar, with reference signal..........................................92
Table of contents
SINAMICS GM150 6SL3810-2LN31-8AA2
Operating Instructions Rev.201910281332 EXAMPLE 11