Technical data and drawings
B
B.1 Technical specifications
An overview of general and specific technical data of the device is provided in the following.
Further, you will find directives relating to the conditions that you must comply with when using
the described device.
B.1.1 Standards and regulations
Table B-1 Standards and conformity
Standards
Standards DIN EN 61800-3/VDE 0160 T103 (IEC 61800-3)
DIN EN 61800-4 / VDE 0160 T104 (IEC6 1800-4), however, only when referenced in the
standards DIN EN 61800-3 or DIN EN 61800-5-1
DIN EN 61800-5-1/VDE 0160 T105 (IEC 61800-5-1)
EU directives 2014/35/EU + amendments (Low Voltage Directive)
2014/30/EU + amendments (Electromagnetic Compatibility)
Certificate of compliance
with order
For the EMC Directive (2004/108/EC + amendments or 2014/30/EU + amendments)
(Product cannot be operated independently; limited distribution channel)
Interference omission This drive unit is part of a PDS, Category C4 according to DIN EN 61800-3/
VDE 0160 T103 (IEC 61800-3). The drive unit has not been designed to be connected to the
public line supply. The equipment can cause electromagnetic interference when it is connected
to the public grid. The essential requirements placed on EMC protection for the drive system
should be secured using an EMC plan at the customer site.
Insulation According to DIN EN 50178/VDE 0160 (IEC 62103), IEC 61800-5-1:
Pollution degree 2 (without conductive pollution), non-condensing
Degree of protection In accordance with DIN VDE 0470 T1, EN 60 529, IEC 60 529
Protection class Class 1 according to DIN EN 61800-5-1/VDE 0160 T105 (IEC 61800-5-1)
Touch protection DIN EN 50274/VDE 0660 T514
SINAMICS GM150 6SL3810-2LN31-8AA2
Operating Instructions Rev.201910281332 EXAMPLE 207
To Next Page
Loading...
