Siemens SINAMICS GM150 - Fault;Alarm Memory

1)
The command data set that must be enabled for setting the relevant main setpoint is indicated
in the square parentheses of the parameter [ ]. In the factory setting, command data set 0 is
active.
Permanent parameter acceptance
The parameters are saved on the CompactFlash card using this menu.
You can find further information on this in the "Permanently saving the parameters" section.
8.3.3.3 Fault/alarm memory
Menu structure of the fault memory/alarm memory menu
0DLQPHQX
)DXOW
DODUPPHPRU\
Figure 8-8 Menu structure for fault memory/alarm memory
Alarm overview
If a fault occurs, the drive displays the associated faults and/or alarms on the operator panel in
the "Alarm overview".
Every fault and alarm is entered in the fault/alarm buffer along with time the fault occurred. The
time stamp refers to the relative system time in milliseconds (r0969).
The diagram below shows that currently at least one active fault/alarm is present for the
"VECTOR" drive object. The two other drive objects are fault-free.
ႣႭ
&8B*
9(&725
70




)DXOW$ODUP
'LDJ7RROV
$ODUPRYHUYLHZ
Operation
8.3 Operation via the AOP30 operator panel
SINAMICS GM150 6SL3810-2LN31-8AA2
Operating Instructions Rev.201910281332 EXAMPLE 121