Siemens SINAMICS GM150 - Connection

8.3.2 Configuration of the AOP30 operator panel
8.3.2.1 Define operation screen
Depending on the type of drive, an operation screen with ten different display parameters is the
default.
9(&7252))
9B'& 9,B,7 $HII
$867 )B2)) +]
3:,5.N:/7,7 
7B/7 r&,',67 $HII
,4,67 $HII8B2)) 9HII
+HOS
FKDQJH
6HO3DU
'LDJ

Figure 8-4 Example of the operation screen
You can customize the display of the operation screen. The following types of display are
available:
● Values
– 2 digital values
– 10 values
The order of the entries in this screen determines the order of the operating variables
(parameters) displayed in the operation screen.
● Bars
– 3 bars
● Mixed
– 8 values / 1 bar
– 4 values / 2 bars
Order of the display: First the parameters to be displayed digitally and then the
parameters to be displayed as bars.
Defining the operation screen
1. Press the <Change> function key. The "Operation screen" menu opens.
ႱႧ
Ⴍ
'HILQHRSHUDWLRQVFUHHQ
2SHUVFUHHQW\SH
6FUHHQW\SH
6FUHHQW\SH
+HOS
%DFN
ႱႧ&KDQJH
YDOXHV%DUV

ႱႧ
$FWLYH
2. Press the <▲> or <▼> function key to select the "Screen 2" entry. Then press the <Change>
function key to change the "Active" setting.
Operation
8.3 Operation via the AOP30 operator panel
SINAMICS GM150 6SL3810-2LN31-8AA2
Operating Instructions Rev.201910281332 EXAMPLE 107