Siemens SINAMICS GM150 - Figure 4-6 Example: Label with Instructions for Opening the Doors; Opening Doors in Preparation for Use

4.4.4 Opening doors in preparation for use
NOTICE
Damage to the locking mechanism caused by incorrectly opening the doors
You can damage the locking mechanism if you open the doors incorrectly.
● When opening the doors, follow the steps described.
● If the locking mechanism is damaged it is essential that you have it repaired before
commissioning the drive system. Contact the service center in this regard. You can find the
relevant contact person under "Service & Support".
The drive is delivered in a closed state. A label showing how to open the doors in a current-free
state is located on the door.
Figure 4-6 Example: Label with instructions for opening the doors
Proceed as follows:
1. There is a screw in the door. Under the screw you will find the opening for manually opening
the doors. Remove the screw.
2. Insert a screwdriver into this opening.
3. Turn the door handle until you feel resistance.
4. Remove the screwdriver from the opening.
5. Open the doors.
After opening the doors, remove the label with the instructions for safety reasons. The label
is only required for opening the doors the first time.
Preparations for use
4.4 Unpacking
SINAMICS GM150 6SL3810-2LN31-8AA2
Operating Instructions Rev.201910281332 EXAMPLE 67