Communication via PROFINET IO
5.10 PROFIenergy
Communication
158 Function Manual, 12/2018, 6SL3097-5BD00-0BP0
5.10.2 PROFIenergy commands
Principle of operation
At the start and end of pauses, the plant operator activates or deactivates the pause function
of the plant/system after which the IO controller sends the PROFIenergy "START_Pause" /
"END_Pause" command to the PROFINET devices. The device then interprets the content of
the PROFIenergy command and switches off or on again.
You can call up device information via additional PROFIenergy functions. You can use these
to transfer the "START_Pause"/"END_Pause" command in plenty of time.
PROFIenergy control commands
START_Pause Switches from the operating state to the energy-saving mode
depending on the pause duration.
Switches from the energy-saving mode to the operating state
depending on the pause duration.
START_Pause_with_time_response Switches from the operating state to the energy-saving mode
and also specifies the transition times in the command re-
END_Pause Switches from the energy-saving mode to the operating state.
Cancels a switch from the operating state to the energy-saving
PROFIenergy query commands
Determines all supported energy-saving modes.
Determines the energy-saving mode.
Determines the current PROFIenergy status.
PEM_Status_with_CTTO Determines the actual PROFIenergy status, the same as for
the command "PEM status" and in addition with the regular
transition time to the operating state.
Determines the supported PROFIenergy commands.
Shows the implemented PROFIenergy profile.
Get_Measurement_List Returns the measured value IDs that can be accessed using
the "Get_Measurement_Values" command.
Get_Measurement_List_with_object
_number
Returns the measured value IDs and the associated object
number that can be accessed using the
"Get_Measurement_Values_with_object_number" command.
To Next Page
Loading...
