Communication via PROFIBUS DP
4.4 Slave-to-slave communication
Communication
102 Function Manual, 12/2018, 6SL3097-5BD00-0BP0
4.4.3 Commissioning PROFIBUS slave-to-slave communication
The commissioning of slave-to-slave communication between two SINAMICS drive devices
using the additional Drive ES package is described below in an example.
Settings in HW Config
Based on the example of the project below, the settings in HW Config are described when
using standard telegrams.
Figure 4-10 Example project of a PROFIBUS network in HW Config
To Next Page
Loading...
