Siemens SINAMICS S120 Series

Communication via PROFINET IO
5.11 Messages via diagnostics channels
Communication
Function Manual, 12/2018, 6SL3097-5BD00-0BP0
161
5.10.6 Function diagrams and parameters
Function diagrams (see SINAMICS S120/S150 List Manual)
•
2381
PROFIenergy
- Control commands / query commands
•
2382
PROFIenergy
- States
•
2610
Sequence control
- Sequencer
Overview of important parameters (see SINAMICS S120/S150 List Manual)
•
r5600
Pe hibernation ID
•
p5602[0...1]
Pe hibernation pause time, minimum
•
p5606[0...1]
Pe hibernation duration, maximum
•
p5611
Pe energy
-saving properties, general
•
r5613.0...1
CO/BO: Pe energy
-saving active/inactive
5.11 Messages via diagnostics channels
Messages are not just able to be displayed via the Startdrive commissioning tools. After the
activation of a diagnostic function, the messages are also transferred to the higher-level
controller via the standardized diagnostic channels. The messages are evaluated there or
forwarded for convenient display to the corresponding user interfaces (SIMATIC HMI, TIA
Portal, etc.).
In this way, problems or faults can be located immediately regardless of the tool currently
being used, and then corrected immediately.
Also note the general information on the diagnostics channels in Section Diagnostics
channels (Page 66).