Siemens SINUMERIK 802D User Manual

Table of contents
Cylindrical grinding
10 Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
10.4.2 Spindle speed limitation: G25, G26 .......................................................................................... 279
10.4.3 Spindle positioning: SPOS........................................................................................................
280
10.4.4 Gear stages...............................................................................................................................
281
10.4.5 2. Spindle ..................................................................................................................................
281
10.5 Special functions .......................................................................................................................
283
10.5.1 Constant cutting rate: G96, G97 ...............................................................................................
283
10.5.2 Rounding, chamfer....................................................................................................................
285
10.6 Tool and tool offset....................................................................................................................
288
10.6.1 General Information ..................................................................................................................
288
10.6.2 Tool T ........................................................................................................................................
288
10.6.3 Tool offset number D.................................................................................................................
289
10.6.4 Selecting the tool radius compensation: G41, G42 ..................................................................
292
10.6.5 Corner behavior: G450, G451...................................................................................................
295
10.6.6 Tool radius compensation OFF: G40........................................................................................
296
10.6.7 Special cases of the tool radius compensation.........................................................................
297
10.6.8 Example of tool radius compensation .......................................................................................
298
10.6.9 Special handling of tool compensation (grinding) .....................................................................
299
10.7 Miscellaneous function M..........................................................................................................
301
10.8 H function ..................................................................................................................................
303
10.9 Arithmetic parameters, LUD and PLC variables .......................................................................
304
10.9.1 Arithmetic parameter R .............................................................................................................
304
10.9.2 Local User Data (LUD)..............................................................................................................
306
10.9.3 Reading and writing PLC variables...........................................................................................
308
10.10 Program jumps..........................................................................................................................
309
10.10.1 Jump destination for program jumps.........................................................................................
309
10.10.2 Unconditional program jumps ...................................................................................................
310
10.10.3 Conditional program jumps .......................................................................................................
311
10.10.4 Program example for jumps......................................................................................................
313
10.11 Subroutine technique ................................................................................................................
315
10.11.1 General information...................................................................................................................
315
10.11.2 Calling machining cycles...........................................................................................................
318
10.12 Timers and workpiece counters ................................................................................................
319
10.12.1 Runtime timer............................................................................................................................
319
10.12.2 Workpiece counter ....................................................................................................................
321
10.13 Inclined axis ..............................................................................................................................
323
10.13.1 Inclined axis (TRAANG) ............................................................................................................
323
10.13.2 Inclined axis (TRAANG)_2 ........................................................................................................
325
10.13.3 Inclined axis programming (G05, G07) .....................................................................................
326
10.14 Multiple feedrate values in one block........................................................................................
328
10.15 Oscillation..................................................................................................................................
330
11 Network operation..................................................................................................................................
335
11.1 Network operation prerequisites ...............................................................................................
335
11.2 RCS802 tool..............................................................................................................................
336
11.3 Network operation .....................................................................................................................
341
11.3.1 Configuring the network connection..........................................................................................
342
11.3.2 User management.....................................................................................................................
344
11.3.3 User log in - RCS log in.............................................................................................................
345

Siemens SINUMERIK 802D Specifications

General

Brand	Siemens
Model	SINUMERIK 802D
Category	Control Unit
Language	English