Siemens SINUMERIK 802D

Cylindrical grinding
Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
335
Network operation
11
11.1 Network operation prerequisites
Introduction
A network function is available for communicating between the control system and a PG/PC.
Prerequisites
The RCS802 tool is required on the PG/PC for communication.
For connecting the control system via the network, various options are available.
These options are described in the chapters "RCS tool" and "Network operation".
The connections are enabled via the following control system interfaces:
● RS232 interface
● Ethernet peer-to-peer interface
● Interface Ethernet network (available only for SINUMERIK 802D sl)