Cycles
9.1 Overview of cycles
Cylindrical grinding
154 Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
Grinding cycles
The following cycles can be carried out using the SINUMERIK 802D sl control system:
CYCLE405 Taper grinding
CYCLE406 Z positioning with grinding wheel
CYCLE407 Safety position
CYCLE410 Plunge-cut grinding
CYCLE411 Multiple plunge-cutting
CYCLE412 Shoulder plunge-cutting
CYCLE413 Oblique plunge-cutting
CYCLE414 Radius grinding
CYCLE415 Reciprocation
CYCLE416 Dressing
CYCLE420 General workpiece data
CYCLE430 Dressing with profile roller
CYCLE446 Selection of grinding wheel peripheral speed
CYCLE450 Technological data
CYCLE451 Oblique plunge-cutting with Z allowance
CYCLE452 Longitudinal surface grinding
The cycles are supplied with the tool box. They are loaded via the RS232 interface into the
part program memory during the start-up of the control system.
To Next Page
Loading...
Need help?
General
