Cycles
9.10 Shoulder plunge-cutting – CYCLE412
Cylindrical grinding
184 Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
A_SR Roughing allowance
A_SL Finishing allowance
F_SR, F_SL (feedrate)
Different feedrates can be specified for the individual machining steps. They are
programmed in [mm/min].
F_SR Feedrate for roughing
F_SL Feedrate for finishing
TIME (sparking-out time)
After reaching the workpiece finished dimension, the tool dwells at the end position for a
defined time. This time is called 'sparking-out time'. It is programmed in [s].
KS (acoustic emission sensor)
The KS parameter is used to specify whether an acoustic emission sensor is used.
0 = without acoustic emission sensor
1= with acoustic emission sensor
F_KS (feedrate for air grinding)
With an air grinding feedrate, the path between the starting point and the point where the
wheel comes into contact with the workpiece (with the aid of the acoustic emission sensor) is
traversed.
OSW (reciprocation travel)
During shoulder plunge-cutting, this parameter can be used to activate a short-travel
reciprocation. Starting point is the position under X_ST. It is programmed in [mm].
F_OSCILL (reciprocation speed)
The reciprocation speed is programmed in [mm/min].
UWERK
Use the UWERK parameter to specify the peripheral speed of the workpiece in m/min.
To Next Page
Loading...
Need help?
General
