Cycles
9.16 Dressing with profile roller - CYCLE430
Cylindrical grinding
208 Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
Sketch of the geometry parameters
Figure 9-7 Dressing with profile roller - CYCLE430
Programming example
Machining sequence:
● 2-stroke dressing with 0.02 mm dressing amount and 2 sparking-out revolutions every 5
workpieces.
● The number of idle strokes and the peripheral speed ratios of the spindles are stored in
the tool data.
N10 T1D1
N20 CYCLE430(0.02,20,0.2,2,2,35,5)
N30 M30
To Next Page
Loading...
