Programming
10.12 Timers and workpiece counters
Cylindrical grinding
322 Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
Display
The contents of the active system variables are visible on the screen under
<OFFSET PARAM> -> "Setting data" ">" "Times/counters":
Total parts= $AC_TOTAL_PARTS
Required parts= $AC_REQUIRED_PARTS
Number of parts =$AC_ACTUAL_PARTS, $AC_SPECIAL_PARTS not available for display
"Number of parts" is also visible in the AUTOMATIC mode in the "Position" operating area in
the information line.
To Next Page
Loading...
